BMW DISA VALVE INTAKE ADJUSTER UNIT REBUILD UPGRADE RATTLE ALUMINIUM FIX M54 3.0 PART NUMBER: X8R42
PRODUCT DESCRIPTION
Our repair kit in this listing addresses the common failure of the BMW DISA 3.0 ltr intake adjuster valve unit. Our components described herein with the assistance of our supportive instruction media will allow you to replace the faulty components which always fail within the DISA unit, without having to replace it with another OEM part that is going to fail again due to the same manufacture faults. An extremely common fault corrected by our repair kit.
SYMPTOMS OF FAULT
The symptoms of this fault are very obvious; there is a rattling noise coming from the DISA valve, SES light is lit and getting a lean mixture fault or rough running at idle. Displaying DTC codes and a loss in low end torque. There may be a rattling, buzzing or clicking noise coming from the engine.
Fault codes: lean condition(P1083, P1085), front oxygen sensor lean (P1090, P1092) oxygen sensor slow response (P1087, P1089) and cylinder misfire (P0311-P0316) fuel control mixture lean (bank 2 sensor 1) and p0174 system too lean, showing?
THE CAUSE
THE ORIGINAL PLASTIC DISA VALVE COMPONENTS WEAR AND OFTEN SNAP CAUSING THE SYMPTOMS NOTED ABOVE.
The pin retaining the flap can also pop out entering the engine! The likely cause of the faults noted above and most common cause is the weak plastic components within the DISA valve unit vibrating together and wearing causing the flap to operate at the wrong times and eventually leading to destruction of the flap plate. The pieces of this flap can even enter the engine often causing severe engine damage; likewise the metal pin that holds the flap plate in position can vibrate loose and enter the engine.
THE SOLUTION
FIT OUR IMPROVED DESIGN BILLET ALUMINIUM FLAP KIT, DESIGNED TO NEVER FAIL, SAVE THE COST OF A REPLACEMENT DISA VALVE WHICH WILL ONLY FAIL AGAIN.
Using our kit, the weak components of the DISA valve flap and crank lever are replaced with our many times stronger billet aluminium parts, retained by our precision machined screw, which tightly holds the two components together; eliminating wear and the need for the retaining pin which can enter the engine. Our part is completely redesigned to never fail- OEM clearances are reduced minimising vibrations in the part, preventing any future failure. Our kit also includes a high temperature Viton 75 O-ring to create a good seal between the DISA unit and the manifold, eliminating any air leaks.
VEHICLES AFFECTED
BMW M54 3.0 & LITER APPLICATIONS E36 1999-2002 Z3 3.0I COUPÉ
E36 1999-2002 Z3 3.0I ROADSTER
E39 2000-2003 530I SEDAN
E39 2000-2003 530I TOURING
E46 1999-2006 330CI CONVERTIBLE
E46 1999-2006 330CI COUPÉ
E46 1999-2005 330I SEDAN
E46 1999-2005 330I TOURING
E46 1999-2004 330XI SEDAN
E46 1999-2005 330XI TOURING
E53 1999-2006 X5 3.0I SUV
E60 2002-2005 530I SEDAN
E65 2002-2005 730I SEDAN
E66 2002-2004 730LI SEDAN
E83 2003-2006 X3 3.0I SUV
E85 2002-2005 Z4 3.0I ROADSTER
BMW PART# 11617544805 OR 11617502275
NUMBER STAMPED ON DISA HOUSING: 7544805 OR 7502275
YOU WILL RECEIVE
Our repair kit includes all the components you will need to restore your BMW DISA unit, you will recieve the components shown above.
